Blood component issues for technicians: component selection, storage, handling, and administration (Proceedings)
This discussion will focus on blood components commonly available and how to choose the appropriate blood component for the patient. Literally volumes of information have been written on transfusion medicine. In the essence of time allotted, this discussion will cover whole blood, packed red blood cells, and plasma. Storage of these blood components, proper handling, transfusion guidelines, and transfusion reactions will also be covered.
The bygone days of routine whole blood therapy
Gone are the days of hastily collecting blood from the clinic's resident cat or dog and then transfusing whole blood to treat every need. The need is clear to make the most of valuable resources, which are the donor and the blood itself. To be efficient the blood must be separated into components and each utilized according to proper indications. There may still be select few times when the use of whole blood best fits the patient's needs. However, there are inherent risks to blood transfusion and it is best for the patient to receive only the component(s) truly necessary. A more judicious use of your hospital blood bank and a possible decrease in owner's costs are additional reasons to use components wisely.Whole blood (WBD)
Considered a full unit 400-450mls blood from a dog, or 55mls from a cat, is collected using an anticoagulant of CPDA-1 or ACD-A. This product will contain the red cells and all plasma components, but will not preserve platelets or white blood cells after aging for more than 4 hours.
Indications and matching. Whole blood contains red blood cells, plasma proteins, coagulation factors, white cells, and platelets. When administered fresh, it may be appropriate for treatment of hemorrhage with concurrent coagulopathies, although there may not be a clinically significant amount of platelets transferred. It is the author's opinion that whole blood is most appropriately used when the changes that occur during packed red blood cell storage are undesirable or when stored blood is not available. Canine matching: Blood from a universal donor (referred to as 1.1negative) should be used unless the recipient has been identified by card test (DMS Labs, KS) or laboratory method as 1.1positive. If the patient is typed as 1.1positive then blood from a 1.1,4 donor is utilized. Full cross matching should be performed if the recipient has been previously transfused. A Coombs test should be performed for any suspected IMHA patient. Feline matching: All recipients must be typed using a card test or lab method. Blood would then be chosen from a corresponding A or B donor. Full cross matching should be performed if the recipient has been previously transfused.
Contraindications. Or better expressed as reasons not to choose whole blood-
Storage, handling and expiration. Donor PCV will vary according to cat or dog blood. 1-6 degrees Celsius; room temperature if platelets are desired. Platelets are not viable after 4 hours or upon refrigeration. Coagulation factors are not viable after 8 hours of collection. Red blood cells are viable for 21 days storage. Stored units of whole blood should be warmed to 37 degrees if time allows before administration.
Side effects. Immunologic hemolytic transfusion reaction: Red blood cell antigen mismatch can lead to acute or delayed transfusion reactions. In the dog, DEA 1.1 mismatches lead to acute reactions; and other DEA mismatches lead to delayed transfusion reactions. In the cat, acute reactions occur with mismatches between Type A and Type B blood. Acute reactions may be fatal and occur immediately or up to 24hrs. Signs may include shock, fever, dyspnea, DIC, hemoglobinuria, hemoglobinemia, hyperbilirubinemia, renal failure, chills, pain. Delayed reactions are not typically fatal and may occur 4-14 days later. Signs may include continued anemia, fever, hemoglobinuria, and hyper-bilirubinemia.
Non-immunologic hemolytic transfusion reaction: The signs are the same as noted above but may be caused by-bacterial contamination, processes within IMHA recipients, concurrent administration of hypotonic fluids with blood, or other mechanical lysis.
Allergic reactions: Urticaria, wheezing, angioedematous reactions, broncho spasm, dyspnea, and pulmonary edema. Four types of allergic reactions are recognized; with type 1 described above being the most commonly seen.
Alloimmunization (sensitization) of recipient: Red blood cell antigens promote the strongest immunogenic response. Mismatches lead to antibody production and to sensitization of the patient to future transfusions. Careful blood typing and cross matching will help to avoid sensitization to antibodies.
Circulatory overload: May occur with cardiac patients or fluid challenged patients. Evaluate fluid load carefully and monitor central venous pressure.
Pulmonary thromboembolism: Signs may include very rapid respirations, dyspnea, cyanosis, pulmonary edema, pleural effusion. An in-line blood filter should always be used during administration.
Infectious disease transmission: Thorough screening of donor pool must be employed to avoid FIV, FeLV, Babesia, Ehrlichia, Leishmaniasis, Mycoplasma, and microfilaria transmission.
Bacterial contamination: Aseptic collection and processing of blood is crucial.
Citrate toxicity: Transfusion of multiple units or liver disease may lead to citrate toxicity. Citrate binds with calcium which can lead to hypocalcemia. Signs may include tremors, seizures, and arrhythmias.